Amway 100186 UV Carbon Replacement Cartridge for eSpring Water Purifier System.
The eSpring UV 100186 cartridge has a patented carbon-block filter to reduce more than 140 potential health-effect impurities.
Amway eSpring replacement filters allows beneficial minerals like calcium, magnesium, and fluoride to pass through.
Amway 100186 UV eSpring Carbon Block Filter Water Purifier reduces: 140 potential health-effect impurities, like pesticides, MTBE, lead, and mercury.
Has a UV bulb that destroys 99.9% of bacteria, viruses, and cysts.
Amway 100186 Replacement Filter Cartridge for eSpring Water Filter System: The auxiliary faucet should be in the "on" position, with the supply water turned off when changing the eSpring Water Purifier replacement filter or during flushing.
It is recommended that the replacement filter for eSpring Water Purifier System should be changed after a year or 1,320 gallons, whichever comes first.
This has been determined after performance testing and failure to maintain as per recommendation may impair performance.
The LED display of the Water Purifier System will indicate when it is time to change the filter. The LED indicator resembles the gas gauge on a car. As the filter reaches the end of its life, the last bar becomes yellow and the unit beeps once when activated. The bar becomes red when it is time to change.
The display unit of the eSpring Water Purifier System will highlight when your battery is dead. It is best to change the batteries along with the filter even if there is life in the battery. Changing the batteries will not reset your unit.
The filter of the eSpring Water Purifier is easy to change.
The eSpring replacement filter screws in like a light bulb.
The eSpring monitor automatically resets itself when the filter is replaced. In case your Water Purifier system beeps or makes a constant tone after filter replacement, it is likely that the top filter is not installed correctly.
Take the following actions:
1. Remove the top shroud (display/cover) and new filter again.
2. Reinstall the filter – press into the bracket and then twist to thread it until it comes to a stop.
3. Align the top shroud properly.
4. If it's correctly seated, there should be no gap between the top shroud and the base housing.
Please note this is ordered directly from the distributor and takes approx 3-4 weeks.